UNIVERSAL
passenger mat emulator

Application: BMW
MERCEDES
MINI COOPER
MAZDA

Thanks to this emulator you can check the correctness of the action of the airbag seat sensor. The emulator is used for diagnostic purposes.

The seat Occupancy Sensor Emulator is used to diagnose damage in the SRS system and allows you to confirm or exclude damage to the mat in the passenger seat.

The emulator connected in place of the original mat sends information to the airbag controller that:
* There is a working mat in the seat
* A passenger sitting on the seat

The emulator should be connected to the car's installation in place of the damaged mat. Find the seat mat connector under the passenger seat, remove the mat wires from the plug and check which ground, signal and power are. Then swap them with the emulator wires.

Wires designation:
Brown - GND (ground)
Green - signal
Red - 12V (power)

Before connecting the emulator use multimeter to check the correct power supply 12V, GND and signal.
Do not place the child seat on the front passenger seat. Passenger airbag during a collision will open.